iSTA Breeze 24V 1500W Pro Charge Controller

 

 

  • Yeni Kontroller 1
  • Yeni Kontroller 1


Product Description: 

 

1.5Kw 24v  is new generation Pro Charge Controller. This device is not hybrid but it can be integrated into hybrid system, (important thing is suitable battery and suitable system). Solar charger and Wind charger can be connect parallel into same battery group.The high-end device can also be used as a monitoring system. It is used to safely and efficiently charge and control your battery with the Wind Generator.

With its discreet appearance, simple operation, with integrated protection functions, this device has high efficiency and low no-load losses. This version of the controller will significantly increase the life and stability of the whole system, especially the batteries.

In addition, the control electronics in the control cabinet monitors system voltage and brakes the wind turbine when reaching a max. Overvoltage.

The special features and product information are listed below:

Use of external and high quality (Triacs), solid state components. Increasing the life of the controller.

Microprocessor controlled charge with integrated voltage and current limiting.

Electromagnetic brake control.

Integrated 3-phase short-circuit breakers (brake switch)

Protection against lightning strikes.

Protection against overcharging, deep discharge, short circuit, overload.

Integrated display.

The generator is automatically braked gently when the battery is full, modern braking system with external load resistance (Dump Load) to avoid immediate blockage of the turbine. Increasing the life of the stator  

 

 

 


 

PRODUCT SPECIFICATIONS
Battery Voltage Nominal
24VDC
Max İnput Power Wind Turbine
1.6 KW
Lcd with Display
Amper, watt, battery voltage,brake, temperature
Charging Voltage
25,2V
Charging Current Wind amperes Max
60A
Generator On / Off switch
After generator stop(after manual brake)  please press mode 1 (off), and generator is locked.(safe braking is achieved in this way)
  for active operation, please press mode 0 (on) and then close manual brake button
Manuel Brake Button
1- for manual brake, please press "off" mode
  2- for operation, please press "on" mode 
Reset Button
This button deactivates when generator was on automatic brake 
Battery Voltage Min
21V
Automati Brake for Wind Turbine (Over heating)
50 °C breaking / 45 °C break out
Wind turbine stop charging voltage
28,8V -+ 1
Wind turbine Recharge voltage
26,9V -+ 1
Cooling
External aluminium cooling wings
Cable Termination
Battery (10mm) - Wind turbine and dumpload (6mm) - Ground (4mm)
Protection Class
IP20 (inside area)
Dump Load
 1.5kw braking resistor (The lod resistance can deviate from picture)
Operational Temperature
  Normal: 20~+55°C/35~85%RH Industrial: 30~+55°C/35~85%RH
Temperature Conpensation
   -4mV°C/2V, -35°C-- +80°C, Accuracy: ±1°C
Size
  30*30*20 cm 

   Weight

 7 kg

   Recommended Battery min

 Acid & Gel (It can be redesign according to Lithium batteries)